XY-2450-160 Dehydration and Fine Sand Recovery Machine Optimal Gradation

XY Dehydration and Fine Sand Recovery Integrated Machine with Polyurethane Lined Hydrocyclone

Closing the Loop in Wet Processing

The XY Dehydration and Fine Sand Recovery Integrated Machine is not a modified sand washer or an add-on screen. It is a purpose-built, dual-function system that simultaneously dewaters material and recovers fine sand from wastewater. Developed from European and American engineering principles and refined for China’s green development strategy, it addresses a simple but costly reality: most wet processing operations lose valuable fine material every minute they run.

What Gets Lost, Gets Recovered

In any sand washing or mineral processing line, the smallest particles are the hardest to retain. Conventional equipment simply cannot capture fine sand in the 0.1–0.35 mm range before it flows into settling ponds or tailings storage. The XY machine changes this outcome. Using a semi-closed design and a polyurethane-lined hydrocyclone, it achieves a recovery rate exceeding 90%. Material that once was a disposal problem becomes a stackable, sellable product.

Three Pressures, One Solution

Operators today face three converging pressures: rising waste disposal costs, tightening environmental regulations, and the need to maximize output from every ton of feed. The XY machine responds to all three at once.

First, it reduces the volume of tailings and sludge requiring handling and storage. Less material sent to ponds means lower ongoing operating costs and extended facility life. Second, it produces cleaner effluent by removing suspended solids, making it easier to meet discharge standards without expensive chemical treatment. Third, it adds recovered fine sand back to the product stream, increasing total sellable output without additional mining or crushing.

Energy-Conscious Engineering

The XY series achieves its results efficiently. The motor, slurry pump, and hydrocyclone are specified as an integrated system, not independent components. This matching eliminates the common inefficiencies of oversized pumps or mismatched cyclones. The machine produces maximum output per unit of power consumed—directly reducing electricity costs and carbon emissions.

Built to Endure

Reliability in wet, abrasive environments requires precision manufacturing and careful material selection. The XY screen body is machined on a gantry boring and milling system, with side milling and hole boring performed in a single setup. This ensures perfect concentricity of the vibrator assembly, a critical factor for long-term stability. Bearing housings are cast from a special alloy steel that resists wear and prevents the outer race rotation that causes premature failure in ordinary designs.

The vibration system combines shaft eccentricity with eccentric block rotation, delivering strong, consistent screening force without destructive shock loads. The polyurethane-lined hydrocyclone significantly outlasts rubber or unlined alternatives.

From Sludge to Sand

The transformation is straightforward: turbid wastewater enters the system. Cleaner water exits from the overflow. Recovered fine sand is discharged from the underflow, dewatered, and stockpiled. Nothing essential is wasted. The XY machine does not just clean water—it captures value.

Sichuan Xinyida Machinery Co., Ltd.

The XY Dehydration and Fine Sand Recovery Integrated Machine is configurable to specific site conditions. Contact Sichuan Xinyida to discuss your feed characteristics, water management goals, and production targets.