Sand Making Shaft Crusher 80ton/H -140ton/H Vertical Shaft Impact Crusher

XY Vertical Shaft Impact Crusher with Four Working Modes Dynamic Static Balance

Engineered for Efficiency, Built for Reliability

The XY Vertical Shaft Impact Crusher represents a focused response to the everyday challenges faced by sand and aggregate producers. Developed by Xinyida and grounded in proven European and American VSI technology, this machine delivers consistent performance where it matters most: lower wear costs, higher throughput, and less unplanned downtime.

More Than Just a VSI

What makes the XY different is not a single feature but the integration of multiple smart design choices. From the way material moves through the crushing chamber to how wear parts are replaced, every detail has been reexamined. The result is a crusher that works harder and lasts longer while demanding less from your maintenance team.

Smarter Mode Switching

Conventional VSI crushers often require time-consuming disassembly when switching between feed configurations. The XY eliminates this delay with a dual-purpose distributor disk that allows operators to change modes quickly and intuitively. Four distinct operating configurations are available: Rock-on-Rock and Rock-on-Iron, each offered with either full center feed or center feed combined with cascading feed. This flexibility means one machine can handle sand making, aggregate shaping, and powder production without compromise.

Flow That Works With You

Inside the XY, material does not fight against sharp turns or abrupt changes in direction. The hydrodynamically optimized deep-cavity impeller features smooth, curved discharge ports and internal passages that reduce friction and accelerate material flow. The numbers speak for themselves: throughput increases by approximately 30%, and sand making efficiency for 0–6mm material reaches 40–45%. More tonnage passes through the same machine, with less energy lost to internal resistance.

Wear Parts That Last Longer

The operating cost of any VSI is dominated by wear parts. The XY attacks this expense from multiple directions. Each impact block is divided into two symmetrical halves. When the lower section shows wear, simply reverse the block. This straightforward action extends service life by over 48%.

The hammer head follows a modular philosophy. Instead of discarding an entire component when one area wears out, only the damaged section needs replacement. Operating costs drop by more than 30%. The diamond-shaped impact blocks fit more securely than conventional designs, providing superior protection to the vertical plates while absorbing impact energy more efficiently.

For operators processing ultra-hard materials, the Rock-on-Rock mode delivers the lowest wear parts consumption and the most favorable long-term economics.

Built to Keep Running

A bearing failure can shut down a crusher for days. The XY features a completely redesigned bearing housing with an advanced sealing system that keeps dust out and oil in, eliminating the common problem of lower bearing cap leakage. Premium brand bearings and this unique seal combine to double service life compared to conventional designs.

The dual-motor drive and automatic thin oil lubrication system ensure uniform loading across the main shaft, resulting in smoother operation and reduced vibration. Every supporting structure—from the feed hopper to the maintenance platform—has been optimized for safety and accessibility.

Intelligent Control, Minimal Attention

The XY comes standard with an air-cooled thin-oil lubrication system integrated with a PLC automatic control unit and on-site monitoring. Real-time data on feed volume, motor current, oil temperature, and main shaft temperature is continuously displayed. The system provides automatic oil shortage protection and temperature regulation, eliminating daily manual oil refilling.

Bearings operate under ideal conditions, shift after shift. Your team gains peace of mind, and your plant gains predictable, uninterrupted production.